Skip to content

AAS

Jump to bottom
Henk-Jan Lebbink edited this page Oct 20, 2017 · 12 revisions

AAS — ASCII Adjust AL After Subtraction

Opcode Instruction Op/ En 64-bit Mode Compat/ Leg Mode Description
3F AAS ZO Invalid Valid ASCII adjust AL after subtraction.

Instruction Operand Encoding

Op/En Operand 1 Operand 2 Operand 3 Operand 4
ZO NA NA NA NA

Description

Adjusts the result of the subtraction of two unpacked BCD values to create a unpacked BCD result. The AL register is the implied source and destination operand for this instruction. The AAS instruction is only useful when it follows a SUB instruction that subtracts (binary subtraction) one unpacked BCD value from another and stores a byte result in the AL register. The AAA instruction then adjusts the contents of the AL register to contain the correct 1- digit unpacked BCD result.

If the subtraction produced a decimal carry, the AH register decrements by 1, and the CF and AF flags are set. If no decimal carry occurred, the CF and AF flags are cleared, and the AH register is unchanged. In either case, the AL register is left with its top four bits set to 0.

This instruction executes as described in compatibility mode and legacy mode. It is not valid in 64-bit mode.

Operation

IF 64-bit mode
    THEN
        #UD;
    ELSE
        IF ((AL AND 0FH) > 9) or (AF = 1)
            THEN
                AX ← AX – 6;
                AH ← AH – 1;
                AF ← 1;
                CF ← 1;
                AL ← AL AND 0FH;
            ELSE
                CF ← 0;
                AF ← 0;
                AL ← AL AND 0FH;
        FI;
FI;

Flags Affected

The AF and CF flags are set to 1 if there is a decimal borrow; otherwise, they are cleared to 0. The OF, SF, ZF, and PF flags are undefined.

Protected Mode Exceptions

#UD If the LOCK prefix is used.

Real-Address Mode Exceptions

Same exceptions as protected mode.

Virtual-8086 Mode Exceptions

Same exceptions as protected mode.

Compatibility Mode Exceptions

Same exceptions as protected mode.

64-Bit Mode Exceptions

#UD If in 64-bit mode.

Source: Intel® Architecture Software Developer's Manual (OCTOBER 2017)
Generated: 10/20/17 13:38:30

Clone this wiki locally