Skip to content

Hardware Itead Sonoff 4CH

Jump to bottom Edit New page
Xose Pérez edited this page Mar 12, 2018 · 1 revision

Itead Sonoff 4CH

Sonoff 4CH

Property Value
Manufacturer Itead Studio
Product page https://www.itead.cc/sonoff-4ch.html
Wiki page https://www.itead.cc/wiki/Sonoff
Build flag ITEAD_SONOFF_4CH
Voltage 3v3

Introduction

TODO

Flashing

You will have to open the case. There is a 5 pin header with VCC33 (3V3), TX, RX and GND. First button is properly labelled FW/IO0 so all you have to do is to connect TX, RX and GND to your USB2UART programmer, press the button and connect the VCC33 pin to power the board and enter flash mode. One very important thing: the TX and RX pins are crossed. You have to connect TX to your programmer TX and RX to RX.

Issues

TODO

Support

If you're looking for support:

  • Issues: this is the most dynamic channel at the moment, you might find an answer to your question by searching open or closed issues.
  • Wiki pages: might not be as up-to-date as we all would like (hey, you can also contribute in the documentation!).
  • Gitter channel: you have better chances to get fast answers from project contributors or other ESPurna users. (also available with any Matrix client!)
  • Issue a question: as a last resort, you can open new question issue on GitHub. Just remember: the more info you provide the more chances you'll have to get an accurate answer.

Home
Change log

Getting started

Supported hardware and options

Configuration

Integrations

Network

Developers

More around ESPurna

Clone this wiki locally