Skip to content

Hardware Itead Motor

Jump to bottom Edit New page
Xose Pérez edited this page Mar 12, 2018 · 1 revision

Itead Motor Clockwise/Anticlockwise

ITEAD Motor Clockwise/Anticlockwise

Property Value
Manufacturer Itead Studio
Product page https://www.itead.cc/smart-home/motor-reversing-wifi-wireless-switch.html
Wiki page https://www.itead.cc/wiki/Sonoff
Build flag ITEAD_MOTOR

Introduction

TODO

Flashing

1CH - close shot

Very much like the 1CH above (actually the photo above is from the 1CH). The main button is tied to GPIO0 so you can easily enter flash mode powering the board while pressing the button (the one that’s closer to the electrolytic capacitors). Pins 7, 8 and 9 of the PSA-B module are RX, TX and GND. You can use a 3-pin header or pogo pins to connect it.

Issues

TODO

Support

If you're looking for support:

  • Issues: this is the most dynamic channel at the moment, you might find an answer to your question by searching open or closed issues.
  • Wiki pages: might not be as up-to-date as we all would like (hey, you can also contribute in the documentation!).
  • Gitter channel: you have better chances to get fast answers from project contributors or other ESPurna users. (also available with any Matrix client!)
  • Issue a question: as a last resort, you can open new question issue on GitHub. Just remember: the more info you provide the more chances you'll have to get an accurate answer.

Home
Change log

Getting started

Supported hardware and options

Configuration

Integrations

Network

Developers

More around ESPurna

Clone this wiki locally