Skip to content

Uses IoT technology and IFTTT to send you a text message when your smoke alarm rings at home.

Notifications You must be signed in to change notification settings

sidward35/esp8266-smoke-alarm

Repository files navigation

esp8266-smoke-alarm

If a smoke alarm goes off, the microphone will detect it, sending a signal to the ESP8266, which will send a signal to the Maker Channel on IFTTT to send an SMS that the smoke alarm went off.

Installation

0 Plug jumper wires into the “GND”, “3V3”, and “D2” pins on the right side of the ESP8266 NodeMCU V3 board, making sure that on the microphone, “GND” connects to “GND”, “+” connects to “3V3”, and “D0” connects to “D2.”

1 Use the 32-bit ESP8266 Flasher or the 64-bit ESP8266 Flasher (depending on your hardware) to flash the NodeMCU Firmware for ESP8266 Development Board.

2 Download all the .lua files in this repo, and change the key in iftttKey.lua to your own IFTTT Maker Channel key.

3 Use the LuaLoader to load all the .lua files in this repo, as well as set the network connection to your local router.

About

Uses IoT technology and IFTTT to send you a text message when your smoke alarm rings at home.

Topics

Resources

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages