Stock App v13840 on OpenCS18 platform

This release is fully functional and backwards compatible with Presonus stock App v13840. It can be run from USB flash drive and every function works fine! It still lacks WiFi support, but it can be resolved in the future with a variety of WiFi dongles.

User manual for the release can be found Here

Disclaimer

Please note that you are trying this firmware at your own risk. YOU are completely responsible for any damage you can do to your unit while using this firmware. Also, this release doesn’t fix any issues, that present in v13840 Stock App and can even bring a number of unpredicted ones.

How to run it

• Download OpenCS-v1.0.13840.zip archive from assets
• Put 2 files recovery.scr and uImage.presonus-cs18ai on USB stick
• Power off the unit
• Place USB stick in USB connector on the rear of the unit
• Hold Home button
• Power on the unit
• Wait bouncing pattern of the meters
• Release Home button
• Enjoy benefits of OpenCS18

v0.0.2 - Flash dumper

Boots and dumps internal flash contents to the USB stick

Disclaimer

Please note that you are trying this firmware at your own risk. YOU are completely responsible for any damage you can do to your unit while using this firmware. Also, this release doesn’t fix any issues, that present in v13840 Stock App and can even bring a number of unpredicted ones.

How to run it

• Download FlashDump.zip archive from assets
• Put 2 files recovery.scr and uImage.presonus-cs18ai on USB stick
• Power off the unit
• Place USB stick in USB connector on the rear of the unit
• Hold Home button
• Power on the unit
• Wait bouncing pattern of the meters
• Release Home button

you will end up with 4 partitions dump on USB

mtd0
mtd1
mtd2
mtd3

v0.0.1 - just boot

Safely Boots Presonus CS18AI and shows its IP on LCD

Disclaimer

Please note that you are trying this firmware at your own risk. YOU are completely responsible for any damage you can do to your unit while using this firmware. Also, this release doesn’t fix any issues, that present in v13840 Stock App and can even bring a number of unpredicted ones.

How to run it

• Download uBoot.check.zip archive from assets
• Put 2 files recovery.scr and uImage.presonus-cs18ai on USB stick
• Power off the unit
• Place USB stick in USB connector on the rear of the unit
• Hold Home button
• Power on the unit
• Wait bouncing pattern of the meters
• Release Home button
• Enjoy benefits of OpenCS18

it should boot itself like this

Click image to watch boot video

Unzip recovery.scr and uImage.presonus-cs18ai directly to flash drive