DJI Mavic 2 PRO Drone

Here's the manual on how to use the DJI Mavic II Pro Drone.

Please follow the instructions.

Content

• Where To Find
• In The Box
• How To Make It Works
  • Assembly
  • Charging The Batteries
  • Powering Up
• Device's Functionalities and Features
• Safety Guidelines
  • Environmental Consideration
  • Operation
  • Pre-Flight Checklist
• SDK
• Accessories
  • DJI Goggles
  • Mavic 2 Fly More Kit
  • Backpack
• Putting The Device Back
• More Documentations

Where To Find

Storage room - shelf B1

In The Box

1. Aircraft (main unit)
2. Remote Controller
3. Box 1

• Documentations: quick start guide, in the box, support contact, Intelligent flight battery safety guideline, Disclaimer and safety guidelines)
• 3x bags with two pairs of propeller (fan blades) in each bag.

4. Box 2: power adapter and cable
5. Box 3: connection cables : USB adapter, 3x RC cable (one already on the controller), communication cable USB type-c
6. SanDisk Adapter

The whole contents in the box is shown as below in the picture (SD card is not included in the picture).Please check the content when you get the box and return, SD card should be included.

How To Make It Works

Assembly

1. Install the mobile app DJI GO 4 from the app store or googler play DJI GO 4
2. Take the parts out of the box
3. Start by taking the aircraft and remove the gimbal (plastic) cover from the camera
4. Unfold the front arms one by one by pulling it outside away from the aircraft body.
5. Unfold the rear arms by pulling them downwards one by one
6. Take the propellers out of the plastic bag, there are a total of six pairs but you will only need four
7. Take 2 pairs unmarked (black around the hole) and two marked (small white circle around the whole) and match it with mark on the motor
8. Put each propellers one by one by pressing firmly and then rotate as the lock drawing on the top shows. Note: make sure to match the propeller with the correct motor with the same white marking. Also note that not all propellers lockes in the same direction and follow the drawing on top.
9. Check the battery level by clicking on the power button once on the top of the aircraft
10. Check the battery level of the LCD controller by clicking once on the power button on the lcd controller
11. In case either batteries is low on charge, charge it using the power adapter.
12. Unfold the antennas on the top of the remote controller
13. UnfoLd the mobile device clamps on the bottom, then attach the control sticks
14. Attach the controller sticks in its place which could be found under the mobile device clamps.
15. If the RC cable on the left side is not connected then connect and place the other end to the end of the slot.
16. Attach your mobile device.

Charging The Batteries

In case the aircraft and the controller both has enough charge then you can skip this second and move on to the next.

• The power adapter included in the box can charge both the aircraft and the remote controller

• Charging the aircraft (Charging Time ~ 1 hour 30 minutes)

1. Remove the battery from the top of the aircraft by pressing on both buttons on the side
2. Connect the batter to the charger
3. A green indicator blinks showing that the battery is being charged.

• Charging the remote controller (Charging Time ~ 2 hour 15 minutes)

1. Remove the USB cable from the left side of the controller
2. Pull out the small USB cable on the side of the power adapter and connect it to the remote controller.
3. The LCD will lit and shows that the device is charging.

Powering UP

1. Press the power button on the remote controller, then press and hold to power on the remote controller.
2. Press the power button on the aircraft, then press and hold to power on the aircraft
3. Launch the app DJI GO 4.

Device's Functionalities and Features

• Auto take off and auto landing.
• Fly up to 18 km, for 31 minutes with fully charged battery.
• Remote controlled using the controller in the box with range up to 8km
• Live View: streaming live video up to 1080p from the camera on board of the aircraft to the mobile app.
• Video Recording: 4k, 2.7K, FHD video on the SDK card.
• Still photo: single shot, burst shooting: 3/5 frames, auto exposure bracketing (AEB)
• Obstacle Sensing.
• Intelligent Flight Modes : HyperLapse, ActiveTrackTM 2.0, QuickShot, Panorama, and Advanced Pilot Assistance Systems

Safety Guidelines

Environmental Consideration

1. Always fly at locations that are clear of magnetic or radio interference, building and other obstacles.
2. NOT fly above or near large crowds.
3. Be very careful when flying 19,685 feet (6,000 m) or more above sea level.
4. Fly in moderate weather conditions with temperatures between 14 to 104 F(-10 to 40 C) 5.Please take additional caution while flying indoors because the aircraft stabilization featurs maybe interfered with.
5. DO NOT fly when the wind speeds exceeding 10 m/s or 22 mph.

Pre-Flight Checklist

1. Ensure the stickers on the camera, vision system and infrared sensing system are removed before use.
2. Ensure to remove the gimbal cover before powering on the aircraft.
3. Ensure the remote controller and aircraft batteries are fully charged
4. Please ensure that the arms of the aircraft are all unfolded before flying. Ensure the Intelligent Flight Battery is mounted firmly in place.
5. Ensure the propellers are in good condition and securely tightened before each flight
6. Ensure there is nothing obstructing the motors.
7. Check that the camera lens and sensors are clean and free of stains.
8. Only calibrate the compass when the DUI GOTM 4 app or the status indicator prompt you to do so.
9. Ensure the DJI GO 4 app and aircraft's firmware have been upgraded to the latest version.
10. Be familiar with the selected flight mode and understand all safety functions and warnings.
11. Ensure that your flight area is outside the GEO Zones and flight condtions are sutable for flying the aircraft.
12. Ensure the DJI GO 4 app is properly launched to assist your operation of the arcraft. WITHOUT THE FLIGHT DATA RECORDED BY THE DUI GO 4 App, IN CERTAIN SITUATIONS (INCLUDING THE LOSS OF YOUR AIRCRAFT) DJI MAY NOT BE ABLE TO PROVIDE AFTERSALES SUPPORT TO YOU OR ASSUME LIABILITY.

Operation

1. DO NOT start the motors before unfolding the arms. Otherwise it may damage the aircraft
2. DO NOT touch the battery buckles while holding the aircraft to avoid it dropping off.
3. Stay away from the rotating propellers and motors.
4. Maintain visual Ine of sight of your aircraft all times.
5. DO NOT answer incoming calls, text messages or do anything that may distract you from ope your smart device to control the aircraft during flight
6. DO NOT fly under the influence of alcohols or drugs
7. DO NOT fly close to reflective surfaces such as water or snow, as these types of terrain may affect the performance of the vision system. Only fly the aircraft in environments with good lighting and visibility when GPS signal is weak.
8. Land the aircraft in a safe location when there is a low battery or high wind warning.
9. Please set the Return-to-Home (RTH) Altitude at a level higher than surrounding obstacles using the DJI GO 4 app.
10. The aircraft obstructions during RTH when the visual system is disabled. Use the remote controller to control the aircraft's speed and altitude to avoid collisions during RTH.
11. After landing, first stop the motor, then turn off the intelligent flight battery, and then turn off the remote controller.
12. When using Intelligent Flight Modes, be prepared to take control of the aircraft pushing the sticks and pressing the Flight Pause button or tap the on-screen stop button. Please note that the aircraft will continue performing the Intelligent Flight functions after you pushed the sticks. Press the stop button on the screen to exit such on-going functions completely
13. The pilot must pay attention and control the aircraft at all times during flight. Safety and flight assistance features such as obstacle avoidance and precision landing are meant to assist the pilot, not to replace their control of the aircraft.
14. Environmental lighting and the surface texture of obstacles may impact the performance of the visual system. Inteligent flight control features such as precision landing obstacle avoidance are disabled when the visual system's functions are impaired. Please refer to the User Manual for more information.

For more detailed safety information, you can go this link. https://dl.djicdn.com/downloads/Mavic_2/20180823/Mavic_2_Disclaimer_and_Safety_Guidelines_EN.pdf

SDK

• To use the SDK and build apps for the device you need to register as developer. Go here then click become a developer.
• Documentation and the SDK files per platform can be found here
• Available SDKs: Mobile, UX, OnBoard, Payload, Windows.
• Features: flight, camera, missions and subsystems.

Accessories

DJI Goggles

DJI Goggles are used to connect the DJI Mavic 2 PRO Drone. The details can be found here.

Mavic 2 Fly More Kit

Here is the external Kit for Mavic 2. Please check the content when you get and return.

1. Bag
2. Shoulder Belt
3. Battery Charging Hub
4. Car Charger
5. Bettery to Power Bank Adaptor
6. Intelligent Flight Battery *2
7. Propellers (one marked, one unmarked) *2 pairs
8. Documentation (MAVIC 2 Fly More Kit)

Backpack

Here is the backpack for drone which helps you easy to carry on.

Putting The Device Back

After finish using the device, it is important to turn off, disassemble and put it back in the box as it was found, then put the box back in its place.

More Documentations

More documentations and materials to download could be found here.