-
Notifications
You must be signed in to change notification settings - Fork 0
Home
Howdy! Bored to run after your Velux remote controller because you can’t remember where you left it? Or maybe you simply would love to be able to use your voice to control them? You’re at the right place for that! Today we are going to review the entire process to implement Snips on your Velux.
This is the goal of this guide (yeah, just to tease you…): Youtube teaser
Just be aware that following this guide will void any warranty on your Velux remote. You are going to solder, cut, tape, glue, screw and neither I nor Snips can be held responsible for any nonfunctional remote, damages or injuries. This hack goes to a working state, without 3d print of a new casing so you are going to end up with an electronic component in the open! You will not be able to use the remote normally anymore but only through your voice or your computer keyboard. In other words, you know what you are doing here! I will gladly provide help on my free time and will update this guide for further addons (error handling, 3d printed casing, electronic board print).