Small cli utility for converting drawing tablet areas, e.g. for when changing drivers. Basically just assuming a linear transform.
Once installed as area-converter, the executable can be used without any parameters; any input is asked for at runtime.
For example:
$ area-converter
What command would you like to run? (type "quit" to exit, "help" to display supported commands)
> convertArea
Please enter the old full area values
<left value> <top value> <right value> <bottom value>:
> 0 0 1000 1000
Please enter the old desired area values
<left value> <top value> <right value> <bottom value>:
> 23 27 720 410
Please enter the new full area values
<left value> <top value> <right value> <bottom value>:
> 0 800 600 0
I think the new desired area is:
(left, top) -> (right, bottom) : (23.000000, 333.400000) -> (441.200000, 27.000000)
What command would you like to run? (type "quit" to exit, "help" to display supported commands)
> quit
$
To build, first clone and enter the repository:
$ git clone https://github.com/Luminiscental/area-converter
$ cd area-converter
The project uses stack, so you will need that to compile from source:
$ stack build
After the executable has been built you can run it in the source directory:
$ stack run
Or install it:
$ stack install