This project is an advancement of markmaker's PushPullFeeder. Instead of OpenSCAD, this project uses a parametric approach in Autodesk Fusion 360. The main goal is to create a fully 3d-printed feeder for the LumenPnP, which fulfills the goals stated below.
-
Fully 3d-printed
-
Printable on smaller printers (e.g. Prusa Mini)
-
Tape insert should be parameterized
-
LumenPnP can be operated on the ground (component reel must not be the lowest point of the PnP machine)
-
Optimized in terms of filament usage
Make sure you have installed Fusion 360 and know the basics on how to use it.
-
Open the
LumenPPF.f3zfile inside of Fusion 360.- Note: the usage of the
.stepfile in theSTEPfolder is not recommended
- Note: the usage of the
-
Open the
Change Parametersoption and adapt the feeder to your needs. -
Export the tape insert and the lever since the other parts usually stay the same (8mm version)
-
Print all parts from the
STLfolder and the exported tape insert + lever -
Assemble the feeder
-
Enjoy 🎉
-
Create a pull handle for the LumenPnP X-gantry -
Adapt the project for other tape sizes than 8mm
-
Improve the mounting handle
-
Test the design
This project is provided as-is! Please feel free to adapt it to your needs and contribute to the project. I would be very grateful to include your improvements. Thanks for your support!
WARNING: Everyone is responsible for what he/she is doing! I am not responsible if you hurt yourself, torch your house or anything that kind trying to build/improve your coffee grinder! You are doing everything at your own risk!