No matter what I do, I can't generate a project

[Clos97]

As you can see in the image below, I'm always getting a FileNotFoundError when I'm trying to generate a project.
I've used the example explaination shown in the documentation. I've generated code via CubeMX and when I'm trying to run the command stm32pio new -b nucleo_l152re I'm facing this issue.

[ussserrr]

What's the content of the folder where you are running this command in?

[Clos97]

It's happening if I run it with just the ioc file in the directory or with a generated project including the sources.

[ussserrr]

Hmm, can you specify this file explicitly? Also, try with a verbose mode to collect more information.

[Clos97]

sure.
these are the files that are inside of my project folder:

When I put the verbose flag into the command, the result looks like this:

[ussserrr]

Where is the CubeMX located? Does the default path (on screenshot) that stm32pio assumes when tries to invoke the CubeMX is sufficient for your installation? If not, you can set the correct one at the INI-config.

[Clos97]

The Cube MX path is the same as it is defined in the .ini file:
"C:\Program Files\STMicroelectronics\STM32Cube\STM32CubeMX\STM32CubeMX.exe"

[Clos97]

Is there any update? Is the Path I'm using wrong or what's the issue?

[ussserrr]

The log saying there are some problems with invoking of CubeMX CLI but that's all. This issue is strange tbh, I don't think I have enough ability to solve it for your particular setup.