Replies: 4 comments
-
Additional info: if I log
which means that it first always thinks that it's disconnected but after a retry it just returns the value fine... Also |
Beta Was this translation helpful? Give feedback.
-
And here's the exception I'm getting when saving the config, if it helps anything:
|
Beta Was this translation helpful? Give feedback.
-
Hm, it looks like totally erasing the flash and uploading a non-debug image solves the issue 🤷 |
Beta Was this translation helpful? Give feedback.
-
Try a full reset (Through the WiFi AP), there was a change to the file system. Sometimes the filesystem needs a rebuild. |
Beta Was this translation helpful? Give feedback.
-
Hi!
I have an iSpindel that had some minimal damage due to insufficient insulation, i.e. the wort went in a bit... I disassembled until I was able to remove the switch and clean it - according to my measurements all the other components & connections look OK after re-assembly.
While I was there I thought it's a great idea to flash the firmware to latest - version 7.3.3.
Now I have a strange effect: I cannot save the WiFi config as it crashes. Presumably because I also get repeatedly:
BUT, if I go to the info page, I get totally meaningful temperature values, even when I touch the sensor it detects the warm up caused by my hand.
So, I guess the config save crash is due to the OW issue, but then, why is that present, if the sensor looks to be working, and all the connections / resistance values on the 3 legs of the temp sensor look OK otherwise?
Any help is appreciated, thanks!
Beta Was this translation helpful? Give feedback.
All reactions