Cannot persist change of AP after initial configuration

[josh208]

Using I2S-4MFlash-1681 16bit on Louder-ESP32 WROVER.

I initially configured the device in my work area which has it's own AP. I then tried to switch to my main house AP. It would connect, but after rebooting it would always revert back to the originally configured AP. I also noted that after switching APs, tring to play anything via LMS or CSpot would cause it to reboot (which of course reverted to original AP). For kicks, I tried changing/saving various settings incuding NVS to get it to take. I even tried making the original AP unavailable and connecting to the SofttAP and selecting the new AP. Again it would revert to original. The only way I was finally able to resolve this was to re-install firmware w/ Erase.

1. Observed Behavior: Changing to a new WiFi access point does not persist after reboot.
2. Expected Behavior: Once I select a new AP, it should persist.
3. Steps to Reproduce: Set AP during initial config. Reboot. Change to a different AP. Reboot. (will be reverted to initial AP).