#T-Box v1.1 rev 2 Throughhole version of PCB using an Atmega328P chip.
#Source Code In the settings.h file you will need to change the following lines
#define rssiPinA A6
to
#define rssiPinA A2
and also
#define rssiPinB A7
to
#define rssiPinB A3
####BOM
- 3x 1k resistor
- 2x 100k resistor
- 3x 330 resistor
- 2x rx5808 receiver with spi mod
- 3x 5mm LEDs
- 3x Miniature Tactile Button (9.5mm high if using T-Box enclosure)
- 1x DSN-MIN-360 Step Down regulator.
- 2x RP-SMA/SMA connector board mountable
- 1x 4066 digital switch chip
- 1x Atmega328p (WITH ARDUINO BOOTLOADER!!)
- 1x 16.000Mhz Crystal
- 2x 22pf Cap
- 1x 0.1uf Cap
- 1x 10k resistor
- 1x OLED 128x64 display I2C (5v tollerant) Pin order must be VCC GND SCL SDA
Board available at OSHPark
#T-Box v1.0 rev 4 Throughhole version of PCB using an Arduino Pro Mini
####BOM
- 3x 1k resistor
- 2x 100k resistor
- 3x 330 resistor
- 2x rx5808 receiver with spi mod
- 3x 5mm LEDs
- 3x Miniature Tactile Button (9.5mm high if using T-Box enclosure)
- 1x DSN-MIN-360 Step Down regulator.
- 2x RP-SMA/SMA connector board mountable
- 1x 4066 digital switch chip
- 1x Arduino Pro Mini
- 1x OLED 128x64 display I2C (5v tollerant) Pin order must be VCC GND SCL SDA
Board available at OSHPark
Schematics and enclosure can be found at T-Box