M532 working too and a question

[addadi]

Hi,
Just wanted to report that m532 is tested and working too. thank you very much for this project.
Also how do I change the tasmota ble device without going through the full setup?
thanks

[ezfrag2021]

@addadi Did you do anything special to get M532 working? I can see the sensor entities but the cover entity was not created so I cannot control the lock.

[addadi]

@ezfrag2021 nothing special. it just worked for me.

[ezfrag2021]

@addadi Thanks. Did you use Tasmota or the custom ESPHome firmware?

[addadi]

@ezfrag2021 tasmota

[clearwave1]

FWIW - I was successful setting this up on a M532 yesterday using the ESPHome firmware.

I'm not sure why but I found that I needed a couple of restarts of HA before the MQTT publishing was working properly. This integration won't work unless the MQTT publishing from the firmware is working.