You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm trying to get SWV output and so far I'm getting no output. I have semihosting and SWV set up in my firmware and the SWV output is working in STM32CubeIDE.
The CubeIDE support is fine for interactive debugging, but what I really need is to get SWV output into an automated test system, and was hoping PyOCD could enable this.
No SWV output to console. I have tried Telnet to port 3443 (SWV raw server), no output there. I have also tried the telnet option for semihost_console_type, no output there either.
Anything else I can try? I don't know if this is a bug or maybe I just missed something in the docs? I went through several times but maybe I missed a config option or something.
The text was updated successfully, but these errors were encountered:
PyOCD 0.36.0
STM32F334
I'm trying to get SWV output and so far I'm getting no output. I have semihosting and SWV set up in my firmware and the SWV output is working in STM32CubeIDE.
The CubeIDE support is fine for interactive debugging, but what I really need is to get SWV output into an automated test system, and was hoping PyOCD could enable this.
Here's my setup:
PyOCD:
My clock settings are correct, they match my working Cube config.
Then I run GDB:
No SWV output to console. I have tried Telnet to port 3443 (SWV raw server), no output there. I have also tried the telnet option for semihost_console_type, no output there either.
Anything else I can try? I don't know if this is a bug or maybe I just missed something in the docs? I went through several times but maybe I missed a config option or something.
The text was updated successfully, but these errors were encountered: