-
Notifications
You must be signed in to change notification settings - Fork 13
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
ERROR: EEPROM verify failed #55
Comments
Hi Levi,
That's an unusual error. If you've wired up your P1 yourself, make sure to
follow EEPROM connections like shown in this diagram. If you did wire it
yourself, most likely this is a case where something isn't connected as
recommended. If you are using something like a Propeller FLiP or some
other board that already includes a P1 + EEPROM, then most like the problem
is something else, including the possibility that the EEPROM is actually
bad or worn out, in which case you'll need to contact ***@***.*** to
request an RMA and replacement.
[image: image.png]
The fact that it downsteps the baud rate first means that it's having
trouble communicating with the Propeller, so perhaps it's a board (or
self-wired unit) that doesn't have a fast Crystal attached? (ie: it's
using the internal fast RC Oscillator only). That could also be caused by
a poor-quality USB cable; some don't have very good shielding and may allow
for a lot of communication noise.
*Jeff Martin, R&D + IT*
916.625.3002
***@***.***
www.parallax.com and learn.parallax.com
[image: See Sale Details]
<https://www.parallax.com/parallaxs-microbit-shop-is-a-one-stop-source-for-curriculum-and-hardware/>
…On Sun, Jul 7, 2024 at 6:54 PM Levi ***@***.***> wrote:
I am getting the following in the terminal when attempting to flash a
P8X32A-D40.
proploader.mac -k -D baud-rate=115200 -p /dev/cu.usbserial-P97z9aa5 "~/pixelmusic3000e.binary" -e
Opening file '~/pixelmusic3000e.binary'
Stepping down to 460800 baud
Stepping down to 230400 baud
Stepping down to 115200 baud
Using single-stage download
Downloading file to port /dev/cu.usbserial-P97z9aa5
12156 bytes sent
Verifying RAM
Programming EEPROM
Verifying EEPROM
ERROR: EEPROM verify failed
ERROR: Download failed
Press return to continue...
—
Reply to this email directly, view it on GitHub
<#55>, or unsubscribe
<https://github.com/notifications/unsubscribe-auth/AAJVFDRLCBX4PBRBNXWJ37LZLHWN7AVCNFSM6AAAAABKP4G4M6VHI2DSMVQWIX3LMV43ASLTON2WKOZSGM4TINBSGI2TEMY>
.
You are receiving this because you are subscribed to this thread.Message
ID: ***@***.***>
|
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
I am getting the following in the terminal when attempting to flash a P8X32A-D40.
The text was updated successfully, but these errors were encountered: