Case files are included for left and right cases. Cases can be used with or without tenting.
If you would like tenting, print the tented legs STL for approximately 20 degrees of tenting. Legs can be swapped for others of different heights to achieve different angles. I plan on creating a few variants in the future and uploading them here.
- 10 - M2 x 10mm Screws https://www.mcmaster.com/91200A106
- 10 - M2 Heat-set Inserts https://www.mcmaster.com/94180A312
- PCB Kit Boardsource.xyz Microdox
- 10mm Rubber Feet Amazon Link
- 4 - M3 x 10mm Screws https://www.mcmaster.com/92095A182/
- 4 - M3 Heat-set inserts https://www.mcmaster.com/94180A331
If you are in the US McMaster-Carr should get you your materials within a week.
You have a few options here, you can either purchase the case kit from Boardsource.xyz which will provide you with the OLED cover as well, or you can opt for a brass plate.
For the brass plate I went with SendCutSend and purchased 1.6mm brass plates for $20 ish a plate.
Plate files can be found at https://github.com/boardsource/microdox-goodies
Resolution: 0.2 Supports: Doesn't matter Infil: 35%