Unable to flash coral dev board with Yocto Zeus(Flashing problem)

[alphaanyms05]

I built a Yocto Zeus image successfully.
Now, I am flashing coral board using the SD card flashing method. I am getting the following errors:

Console Logs:

U-Boot SPL 2017.03.4-release-day+g8523a101cd (May 12 2021 - 13:22:06)
power_bd71837_init
pmic debug: name=BD71837
Board id: 0
start to config phy: p0=3200mts, p1=667mts with 1D2D training
check ddr4_pmu_train_imem code
check ddr4_pmu_train_imem code pass
check ddr4_pmu_train_dmem code
check ddr4_pmu_train_dmem code pass
config to do 3200 1d training.
Training PASS
check ddr4_pmu_train_imem code
check ddr4_pmu_train_imem code pass
check ddr4_pmu_train_dmem code
check ddr4_pmu_train_dmem code pass
config to do 3200 2d training.
Training PASS
check ddr4_pmu_train_imem code
check ddr4_pmu_train_imem code pass
check ddr4_pmu_train_dmem code
check ddr4_pmu_train_dmem code pass
pstate=1: set dfi clk done done
Training PASS
Load 201711 PIE
Normal Boot
Trying to boot from MMC2
hdr read sector 300, count=1

U-Boot 2017.03.4-release-day+g8523a101cd (May 12 2021 - 13:22:06 +0000)

CPU: Freescale i.MX8MQ rev2.1 1500 MHz (running at 1000 MHz)
CPU: Commercial temperature grade (0C to 95C) at 40C
Reset cause: POR
Model: Freescale i.MX8MQ Phanbell
DRAM: 3 GiB
Board id: 0
Baseboard id: 1
MMC: FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial

BuildInfo:

ATF 1cb68fa
U-Boot 2017.03.4-release-day+g8523a101cd
flash target is MMC:0
Net:
Warning: ethernet@30be0000 using MAC address from ROM
eth0: ethernet@30be0000

Has anyone faced the same problem? Help me