This is the build guide for Corne Cherry v4.
| Name | Count | Remarks |
|---|---|---|
| PCB | 1 set | |
| Case | 1 set | |
| Switch plate | 1 set | FR4 1.6mm thick |
| Key switches | 42 - 46 | Only Cherry MX compatible |
| Keycaps | 42 - 46 | 1u 40 pcs, 1.5u 2 pcs |
| Spacer M2 | 8 | 7.5 mm For Case assembly |
| Screw M2 | 16 | 5 mm For Case assembly |
| Rubber cushion | 8 | |
| TRRS (4 poles) cable | 1 | v4.0.0: TRS (3 poles) cable is not compatible v4.1.0: TRS (3 poles) cable is compatible |
| Type-C cable | 1 |
| Name | Count | Remarks |
|---|---|---|
| Rotary Encoder | 0 - 4 pieces | compatible product of the rotary encoder EC12 |
please see docs/firmware/rev4.
This is the build guide for the left hand side. The right side is the same procedure.
If a rotary encoder is used, it can be attached instead of a switch at the position shown in the figure below. In that case, soldering from the back side is required.
