Connecting to GoPro HERO 9 using BLE provided by HM-10 module with Arduino UNO board.

[hatimzs]

Hi,
I am currently working on a project to use an Arduino UNO board with a BLE HM-10 module connected in order to activate a GoPro HERO 9. I have very basic experience with BLE connectivity and would appreciate some guidance with the challenge!

I am using the Arduino IDE serial monitor to send AT-commands to the HM-10 module which attempts to connect to the GoPro using its MAC address. I have put the GoPro into pairing mode by following the on screen steps (Connections > Connect Device > Quick App). However, I am unable to establish a connection with the camera.

The HM-10 is able to detect nearby devices and complete the scanning procedure. The code used to interact with the HM-10 is provided below.

Any help with this issue would be greatly appreciated!

test5b.txt