No commands run in the initial microVM

[imyunha]

Hello, everyone. I'm a newbie of firecracker.

I'm following this.
After I run ssh -i ./ubuntu-22.04.id_rsa [email protected] , ping, apt, ... all commands don't work.

I added nameserver 8.8.8.8 to /etc/resolv.conf, but it doesn't work. Any other solutions?

[wearyzen]

Hi @choiyhking, getting started guide just covers how to quickly bootup a uVM and test it locally. To connect the uVM to the internet you'll have to follow some more steps from https://github.com/firecracker-microvm/firecracker/blob/main/docs/network-setup.md.

Sharing reference steps to follow along with the getting started page:

1. Before starting Firecracker, run the On The Host steps.
2. In the steps from Getting started guide, make sure to use "eth0" instead of "net1" (shared command below for reference)

curl -X PUT --unix-socket "${API_SOCKET}"
--data "{
"iface_id": "eth0",
"guest_mac": "$FC_MAC",
"host_dev_name": "$TAP_DEV"
}"
"http://localhost/network-interfaces/eth0"

3. After the uVM boots up run the In The Guest steps along with echo nameserver 8.8.8.8 > /etc/resolv.conf

Let me know if this helps.

[imyunha]

Hi @sudanl0, Thank you so much for your detail reply.
Originally guest to host ping didn't work either, but this now works fine.
But ping google.com, apt update still doesn't work.

Should I proceed with the advanced part?
(Actually, I'm not good at linux network..it's more difficult to solve)

For now, I'm connected to wi-fi. Is this can be a problem?

[wearyzen]

Hi @choiyhking,
The current steps should have worked to get the ping started.
The networking guide assumes that eth0 is the internet-facing interface but since you use wifi you might need to modify the On Host steps to replace eth0 with the name of your wifi interface as below (it probably would be wlan0):

sudo iptables -t nat -A POSTROUTING -o `YOUR_WIFI_INTERFACE_NAME` -j MASQUERADE
sudo iptables -A FORWARD -i tap0 -o `YOUR_WIFI_INTERFACE_NAME` -j ACCEPT

Could you confirm if using the right wifi interface name on the host works for you?

[imyunha]

After I connected my device to ethernet, I followed getting-started and network-setup.

But in getting-started, I modified MASK_SHORT="/30" to MASK_SHORT="/24" and used eth0 instead of net1.
And in network-setup, I only used in the guest part.

As a result, network problem is solved.

But, apt update made E: You don't have enough free space in /var/cache/apt/archives/.

It looks like rootfs size is too small...how can I size-up?
Should I reference this?

I really appreciate to @sudanl0.😊😊

[wearyzen]

The rootfs mentioned here should already be up to date but yes, in general if you want to try a custom rootfs the link mentioned is the right one.

[imyunha]

Thank you so much. I'll try it. :)