forked from ya-jeks/gsmmux
-
Notifications
You must be signed in to change notification settings - Fork 0
/
README
70 lines (56 loc) · 2.75 KB
/
README
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
GSM 07.10 Driver Implementation with pseudo-tty's
Copyright (C) 2003 Tuukka Karvonen <[email protected]>
Modified 2004/2005 by David Jander <[email protected]>
Development continued in Berlios GSM Multiplexer Daemon project
Introduction
This driver is based on the work of Tuukka Karvonen, (see
README.orig) and has been modified to work with pseudo-tty's
instead. This is far from complete. Please refer to README.orig for
more information about the GSM07.10 implementation. The driver is
known to work with the following modems:
- Sony-Ericsson GM29
- Siemens MC35
- Siemens MC35i
- Siemens MC75
- iRZ MC52iT
- Sony-Ericsson GM47/GM48 (not tested with the most recent version of
the driver)
Instructions for Use
./gsmMuxd [options] <pty1> <pty2> ...
<ptyN> : pty devices (e.g. /dev/ptya0, or /dev/ptmx)
options:
-p <serport> : Serial port device to connect to [/dev/modem]
-f <framsize> : Maximum frame size [32]
-d : Debug mode, don't fork
-m <modem> : Modem (mc35, mc75, generic, ...)
-b <baudrate> : MUX mode baudrate (0,9600,14400, ...)
-P <PIN-code> : PIN code to fed to the modem
-s <symlink-prefix> : Prefix for the symlinks of slave devices
(e.g./dev/mux)
-w : Wait for deamon startup success/failure
-h : Show this help message
This daemon divides one serial port into two or more "virtual" serial
ports (pseudo TTYs) assuming the modem supports the GSM 07.10
multiplexer protocol. This way the first virtual serial port can be
used for e.g. GPRS dialup connection with pppd, while the other ports
are used for modem AT commands.
The daemon takes the pseudo TTY master devices to-be-used as
parameter. The corresponding pseudo TTY slave devices will become the
virtual serial ports.
On some systems, there is only one master pseudo TTY device, the
"/dev/ptmx". In this case, the slave TTYs will be named /dev/pts/0,
/dev/pts/1, etc and the names of the virtual serial ports are not
static. To solve the problem, the daemon can create symbolic links
with static names to the dynamically changing virtual serial port
pseudo TTY slave devices.
INSTALLATION
To make the daemon start at system boot:
1. Copy gsmMuxd to /usr/sbin/
2. Copy the file "mux.d" to /etc/init.d/.
3. Edit the OPTIONS line of the copied file
3. Run chkconfig --add mux.d
If you have more than one modem you will need to
create a copy of the daemon executable with a different
name and create another init script to /etc/init.d/.
Note that installation varies on different systems. The steps above
should work at least on Red Hat linux distributions.