Slicer adds an extra wall in the air before bridging

[marius-chirita]

Hi guys, I am using OrcaSlicer 2.0.0 and I have a top surface orver thin walls (0.8mm). Instead of bridging on the 2 walls, it adds one more internal wall ( in the air) and then the bridge tries to stick to the suspended wall, and it fails. I tried on prusa slicer and on the previous OrcaSlicer version and I am getting the same result. Any idea how to go around this and have the bridge attach to the 2 walls without adding another one ?

[marius-chirita]

So after trying one milion settings, I figured out that this is related to the Wall Loops which was set to 3. I need 3 wall loops below but managed to get the right results with a cube modifier just for the top part.