Prime Tower "issues"

[Durahl]

Greetings!

I'm using OrcaSlicer for my ERCF enabled Voron V2.4 requiring the use of a Prime Tower which generally works but not without "issues".

1. The Moves belonging to what I assume to be the Tip Forming before pulling the Filament out of the Tool Head are SLOOOooww
   Is there a way to speed them up?
2. Today I had to print a bunch of Multi Material Parts with the first Material Change happening somewhere above the 10th layer which means only the 1 Layer of the Prime Tower was "solid" whereas Layer 2 and above were only Walls and Scaffolding. Usually this isn't a problem but today the Filament seemed particularly enamored with the Build Plate resulting in the Prime Tower getting ripped clean off the First Layer when I tried to remove it and as you might guess removing a 1 Layer tall Object off a Build Plate isn't exactly a Highlight ( I had to print a three layer tall square on top of it to peel both off at once ) - Could we perhaps have the Prime Tower use at least two solid AND interlaced layers that will properly stick to each other thus providing a more substantial object to peel off in a case like this?
3. Despite using Rectilinear Interlaced for the Interface Pattern it not always Interlaces them - File of below Image.zip
   
   In the above example the first Support Interface ( purple ) is not being Interlaced while the second ( hidden - further above ) is.

Thanks in Advance!