You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is your feature request related to a problem? Please describe
I using BTT relay as safty measure, for that I need to setup PE4 pin to true during boot to avoid the relay cut the power in the mean time klipper is booting.
If I modify firmware configuration file from the board folder (CONFIG_INITIAL_PINS="PE4"), when the update is checked, from moonraker, is set it as dirty.
Describe the solution you'd like
Put an option to avoid automatic firmware compilation and flashing to allow set CONFIG_INITIAL_PINS before.
Allow, in some way, to set initial pins from the board setup wizard and keep it for later firmware upgrades.
Describe alternatives you've considered
No response
Additional information
No response
The text was updated successfully, but these errors were encountered:
Is your feature request related to a problem? Please describe
I using BTT relay as safty measure, for that I need to setup PE4 pin to true during boot to avoid the relay cut the power in the mean time klipper is booting.
If I modify firmware configuration file from the board folder (CONFIG_INITIAL_PINS="PE4"), when the update is checked, from moonraker, is set it as dirty.
Describe the solution you'd like
Describe alternatives you've considered
No response
Additional information
No response
The text was updated successfully, but these errors were encountered: