feature request: calibration prints and calibration of filament

[Trackhe]

feature request: calibration prints and calibration of filament

i saw the next available features in the index and i m curios to see this. i tried the wifi task already and its very cool.
so my second thought was that creating own filament pre/profiles would be a good extention at the end. and calibration before too. at the end the use can print the RatOS / Mainsail Logo or the 3dbenchy ^^.

oh and please reduce the size or ship only the result later to the image because in my case the whole repository are 400mb with a cm4 module with a 16gb emmc space the 400mb are very mouch space to save. it would also a solution to host that configurator remote and let the site connects to the rpi, that would enable loadingbars for example while a update / restart.

[miklschmidt]

There'll be a lot of features in the future, but the focus is on solving real problems right now, and there are quite a few of those that take precedence:

1. Control board / toolboard flashing wizard (this is done and will ship next release)
2. Kinematics wizard to automatically set motor directions based on a few simple steps.
3. PID tuning
4. Printer and hardware selection with automatic printer.cfg generation.
5. Full blown klipper config wizard (the endgame).

Filament profiles would come after those.

The configurator cannot be hosted remotely, it has to have access to scripts and commands on the pi for the majority of the tasks. The size is fixable, but i'm currently focused on shipping features, so minor optimizations like this will have to come later.

I'll leave this open for now, if someone wants to work on it.

[Trackhe]

Sounds very good.