RAK1921_Jumping_Ball_SSD1306

WisBlock IO RAK1921 OLED Board Programming Guide

This example shows how to use WisBlock IO RAK1921 which is an OLED SSD1306(128*64, I2C) board.

---

Hardware required

---

The following hardware are required.

• WisBlock Base RAK5005-O * 1pcs
• WisBlock Core RAK4631 * 1pcs
• WisBlock IO RAK1921 * 1pcs

Hardware is shown as follows:

Assembled as follows:

For stable connection, please use screws to tighten.

---

Software required

---

To use the environment WisBlock Sensor RAK1906, The following software is required.

• ArduinoIDE
• RAK4630 BSP
• U8g2 library

Connect the assembled hardware to the PC with a USB cable, open the Arduino, and select the development board and port in the tool menu.

Demo

Demo 1

The Demo is designed to display an animated ball on SSD1306.

#include <Arduino.h>
#include <U8g2lib.h>   //https://github.com/olikraus/u8g2

U8G2_SSD1306_128X64_NONAME_F_HW_I2C u8g2(U8G2_R0);

void setup(void) {
  u8g2.begin();
}

//128 * 64
int x = 20;  //  5<=x<=123
int y = 20;  //  5<=y<=59

void loop(void) {
  u8g2.clearBuffer();                   // clear the internal memory
  u8g2.drawCircle(x, y, 5, U8G2_DRAW_ALL);
  central();
  u8g2.sendBuffer();                    // transfer internal memory to the display
  delay(10);
}

int h = 0; // 0 down, 1 up
int v = 0;  // 0 left,1 right

void central()
{

  if (x == 5)
  {
    v = 1;
  }
  if (x == 123)
  {
    v = 0;
  }
  if (y == 5)
  {
    h = 0;
  }
  if (y == 59 )
  {
    h = 1;
  }
  if (v == 1)
    x++;
  else
    x--;
  if (h == 0)
    y++;
  else
    y--;
}

The test results are as follows：