Replies: 5 comments 7 replies
-
Do the sensor have values or are they marked as Unknown? If unknown - this means that the integration no longer provides the sensors - which is what I'd expect. In this case go into HASS settings, go to entities and remove these entities. There should be an icon that shows the unknown ones and you can sort of that column. If they are still reporting values, this means they really have not been removed from the S40 configuration. In this case go into settings integrations and click off the devices link for the integration, find the entities and disable them. |
Beta Was this translation helpful? Give feedback.
-
The prefix comes from the Name the S40 has. So in your system the Name seems to be set to S40 (and for example I have mine set to RageHouse). You may want to check to make sure the name wasn't changed to "S40_3" in the panel. The pattens for entityid is climate.zone If an integration tries to create an entity with an Id that already exists HASS will append an _1 at the end, but since you see the 3 in the middle, I don't think that is happening. The recorder data is tied to the entity id, so you can delete the integration and readd it and you SHOULD not lose the historical data. If the name hasn't changed, we could enable debug logging which would show us exactly why the entity's are being created this way. |
Beta Was this translation helpful? Give feedback.
-
If not done, you may want to do a full restart of HASS, that may sort some of the issues out. Since you are not able to delete the BLE sensors, that means that the integration is registering them at startup, which means that while they are removed from the system they are not removed from the configuration data the S40 sends. This config is gotten from the S40 on every startup. It's also possible that the integration is not interpreting this data correctly when the devices have been removed. Capturing a message log would allow us to see if that is the case or not. |
Beta Was this translation helpful? Give feedback.
-
Attached is my home-assistant.log after enabling Lennox debugging. I configured a separate messages log called nathan_s40.log, but it is still empty after a restart. |
Beta Was this translation helpful? Give feedback.
-
Thanks, that log file had what we needed,
Net is the integration appears to be working properly. Now I don't know why HASS is adding the _3 or why it won't allow you to remove the BLE sensors. It should be easy for me to simulate the Ble sensors being removed. I'll try that over the next couple of days. Here is a process that should get your system cleaned up; or you can wait for me to simulate the removal.
|
Beta Was this translation helpful? Give feedback.
-
My installer added three Lennox BLE Remote Sensors to my S40 for a few weeks, which HA discovered, but now the sensors are removed and returned to the installer as they did not solve my particular problem. The three sensors are deleted from my S40 thermostat but still appear in HA. What is the right way to fully remove them from HA?
Thanks
Beta Was this translation helpful? Give feedback.
All reactions