Problem installing a built image for Orin Nano on nvme. #1523
-
I built the image with the following settings . setup-env --machine jetson-orin-nano-devkit-nvme build_orin After building the bitbake core-image-minimal image The build was successful and I got the image archive. I have flashed the board with the encourage command. Machine: jetson-orin-nano-devkit-nvme
Rootfs device: nvme0n1p1
Found Jetson device in recovery mode at USB 1-2.1
== Step 1: Signing binaries at 2024-04-05T11:21:21:27+03:00 ==
== Step 2: Boot Jetson via RCM at 2024-04-05T11:21:44+03:00 ==
Found Jetson device in recovery mode at USB 1-2.1
== Step 3: Sending flash sequence commands at 2024-04-05T11:21:47+03:00 ==
Waiting for USB storage device flashpkg from ab340003.............. At the same time the output in UART console:
And the flashing process freezes. Any advice on what could be wrong? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 5 replies
-
Looks like the wrong BPMP firmware got loaded. What hardware are you using, exactly, and which branch did you build off of? There was an issue I found during R35.5.0 testing with the initrd-flash script not using the right BPMP firmware for some Orin Nano/NX targets, but that should be fixed in the latest on both the kirkstone and master branches. |
Beta Was this translation helpful? Give feedback.
Sounds like something happened to the USB connection to the device part of the way through the process. Are there any errors in the kernel log on your host? And if you have a serial console connection on your dev kit, was there anything logged there during the process that might point to the problem?