Team meeting 06/12/2020

[Informaticore]

Topics:

FIRST THING: find the right MOSFETS!

Current state of the project

• Replace N-Channel at RTC with P-Channel (see image below) and move the MOSFET to the Regulator sheet @dr-stefan-krank
  
• Use a TestPoint for easy add INT track to MCU if needed (just in case)
• Add DIP-Switch jumper for programming mode to bypass RTC incl debounce (via capacitor)
• Add GND Pin to J5 and J6 (bottom)
• +3.3V Switching change to high side switching (instead of low side currently)
• Research Dual-Channel CMOS component (if we find a good one we go for high side switching on 5V and 3.3V-MCU, if not we keep 5V low-side switching)
• exchange C12 with 1uF instead 0.1uF for better performance

Footprint assignment

• we need to assign/re-assign footprints and remove all errors

BOM

• create a basic BOM for Andreas to give to the manufacturers for a quote

Low Cost Version findings

• FTDI auto flash mode does not works properly. Sometime it goes into flash randomly after shut-down and power back on