printer.cfg

# This file contains pin mappings for the stock 2021 Creality Ender 3
# S1. To use this config, check the STM32 Chip on the V2.4S1 Board
# then during "make menuconfig" select either the STM32F103 with a
# "28KiB bootloader" or select the STM32F401 with a "64KiB bootloader"
# and serial (on USB PA10/PA9) communication for both depending on the
# STM32 Chip installed on your printers Motherboard.

# If you prefer a direct serial connection, in "make menuconfig"
# select "Enable extra low-level configuration options" and select
# Serial (on USART2 PA3/PA2), which is broken out on the 10 pin IDC
# cable used for the LCD module as follows:
# 3: Tx, 4: Rx, 9: GND, 10: VCC

# Flash this firmware by copying "out/klipper.bin" to a SD card and
# turning on the printer with the card inserted. The firmware
# filename must changed to "firmware.bin"

# See docs/Config_Reference.md for a description of parameters.

[include ./hardware/hardware.cfg]

[pause_resume]
recover_velocity: 25

[exclude_object]

[respond]

[include mainsail.cfg]

[include ./macros/macros.cfg]
[include KAMP/*cfg]

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [heater_bed]
#*# control = pid
#*# pid_kp = 71.511
#*# pid_ki = 1.727
#*# pid_kd = 740.143