Heishamon large parallel operation with CZ-TAW1

[rasy35b]

I have purchased on Tindie Heishamon PCB large with ETH module and CM-CNT cable. Software instated on HM is 3.8. I used original cable to connect HP Pana to HM and this bought cable to connect HM to CZ-TAW,1 ETH connected to router and external power supply to USB C port. I can operate (change settings on HP) both way from HM and from Panasonic cloud via CZ-TAW1. So, for instance I can set from Homeassistant Force_DHW_State ON and from Pana cloud I can set also Force DHW state as ON . Is this correct? I have tried to set configuration HM on listening mode but couldn't make this configuration operational and I set on "Enable cztaw proxy port".

[blb4github]

You can both monitor and control the HP from HeishaMon and CZ-TAW1 if the CZ-TAW1 is connected to HeishaMon proxy port. That's the beauty of this! As far as I know Heisamon is not doing any manipulation of messages between HP and CZ-TAW1.