config.h

// PIC24F16KL401 Configuration Bit Settings

// 'C' source line config statements

// FBS
#pragma config BWRP = OFF               // Boot Segment Write Protect (Disabled)
#pragma config BSS = OFF                // Boot segment Protect (No boot flash segment)

// FGS
#pragma config GWRP = OFF               // General Segment Flash Write Protect (General segment may be written)
#pragma config GSS0 = OFF               // General Segment Code Protect (No Protection)

// FOSCSEL
#pragma config FNOSC = PRIPLL           // Oscillator Select (Primary Oscillator with PLL (XT+PLL, HS+PLL, EC+PLL))
#pragma config SOSCSRC = DIG            // SOSC Source Type (Digital Mode for use with external clock on SCLKI)
#pragma config LPRCSEL = LP             // LPRC Power and Accuracy (Low Power/Low Accuracy)
#pragma config IESO = OFF               // Internal External Switch Over bit (Internal External Switchover mode disabled (Two-speed Start-up disabled))

// FOSC
#pragma config POSCMD = XT              // Primary Oscillator Mode (XT oscillator mode selected)
#pragma config OSCIOFNC = ON            // CLKO Pin I/O Function (Port I/O enabled (CLKO disabled))
#pragma config POSCFREQ = MS            // Primary Oscillator Frequency Range (Primary Oscillator/External Clock frequency between 100kHz to 8MHz)
#pragma config SOSCSEL = SOSCHP         // SOSC Power Selection Configuration bits (Secondary Oscillator configured for high-power operation)
#pragma config FCKSM = CSDCMD           // Clock Switching and Monitor Selection (Clock Switching and Fail-safe Clock Monitor Disabled)

// FWDT
#pragma config WDTPS = PS32768          // Watchdog Timer Postscale Select bits (1:32768)
#pragma config FWPSA = PR32             // WDT Prescaler bit (WDT prescaler ratio of 1:32)
#pragma config FWDTEN = OFF             // Watchdog Timer Enable bits (WDT disabled in hardware; SWDTEN bit disabled)
#pragma config WINDIS = OFF             // Windowed Watchdog Timer Disable bit (Standard WDT selected (windowed WDT disabled))

// FPOR
#pragma config BOREN = BOR0             // Brown-out Reset Enable bits (Brown-out Reset disabled in hardware; SBOREN bit disabled)
#pragma config PWRTEN = ON              // Power-up Timer Enable (PWRT enabled)
#pragma config I2C1SEL = PRI            // Alternate I2C1 Pin Mapping bit (Default SCL1/SDA1 Pins for I2C1)
#pragma config BORV = V18               // Brown-out Reset Voltage bits (Brown-out Reset at 1.8V)
#pragma config MCLRE = ON               // MCLR Pin Enable bit (RA5 input disabled; MCLR enabled)

// FICD
#pragma config ICS = PGx1               // ICD Pin Placement Select (EMUC/EMUD share PGC1/PGD1)

// #pragma config statements should precede project file includes.
// Use project enums instead of #define for ON and OFF.

#include <xc.h>